The Rifle kit is a unique and affordable way to personalize your firearm. Made from our “No Glare”, fade resistant material. Your firearm will not only match your hunting environment but will be protected from the elements, giving you lasting peace of mind. Kit includes (4) pre-cut pieces that conform easily to the curves of your barrel, forend, & stock. Matte Finish.
Adhesive vinyl graphic
Fits most Rifles and front loaders
Allows for disassembly of your firearm for routine cleaning and maintenance
|Before Graphic Installation|
|How to Install Your Camo Rifle Kit|
|Your Kit Contains||STOCK & RECEIVER: Pieces are lined up Towards the Rear of the Stock. Make a RELIEF CUTin top of piece as indicated on Diagram Below. Use firm finger pressure to apply, overlapping cut area slightly. Trim with sharp razor blade at front of receiver and ejection port. Use firm finger pressure to conform to stock. Trim flush at bottom of pistol grip. You may have to use cut pieces to cover the bottom area of the Finger Grip.|
FOREND: Trim piece to fit profile of forend. RELIEF CUTS may be necessary at front or rear edge of pieces to conform to forend taper. See Diagram Below. Make sure to cut out any ejection ports you may have on the Forend area.
BARREL: Pieces should be started at a point towards the front of Barrel behind Site. Using firm finger pressure, conform to barrel being sure to overlap at bottom of barrel.
|How to Remove||Heat the Camo with Heat gun or Hair Dryer for several seconds and continue to heat as you peel the material from the surface on a 120° angle. Any residue can be removed with a Citrus Based remover or Alcohol.|
|Relief Cut Diagram|