The shotgun kit is a unique and affordable way to personalize your firearm. Made from our “No Glare”, fade resistant material. Your firearm will not only match your hunting environment but will be protected from the elements, giving you lasting peace of mind. Kit includes (6) pre-cut pieces that conform easily to the curves of your barrel, receiver, forend, & stock. Matte Finish
Adhesive vinyl graphic
Fits most Auto and Pump Action Shotguns 12 Gauge and under
Allows for disassembly of your firearm for routine cleaning and maintenance
|BEFORE GRAPHIC INSTALLATION:||
|HOW TO INSTALL YOUR CAMO SHOTGUN KIT:||
|YOUR KIT CONTAINS:||STOCK: Pieces are lined up at rear of receiver. Provide RELIEF CUTSas shown on Diagram Below. Use firm finger pressure to conform to stock. Trim flush at bottom of pistol grip.
FOREND: Trim piece to fit profile of forend. DO NOT WRAP AROUND EDGES!Relief Cuts may be necessary at front or rear edge of pieces to conform to forend taper. See Diagram Below.
RECEIVER: Line up matching pieces to rear edge of receiver in front of pistol grip. Make sure bottom of piece aligns with bottom of receiver. Make a RELIEF CUT in top of piece as indicated on Diagram Below. Use firm finger pressure to apply, overlapping cut area slightly. Trim with sharp razor blade at front of receiver and ejection port.
BARREL: Pieces should be started at a point forward of rear barrel pieces. Peel Liner from piece, and using firm finger pressure, conform to barrel being sure to overlap at bottom of barrel. It may be necessary to trim edge to fit around barrel lug.
|HOW TO REMOVE:||Heat the Camo with Heat gun or Hair Dryer for several seconds and continue to heat as you peel the material from the surface on a 120° angle. Any residue can be removed with a Citrus Based remover or Alcohol.|
|Relief Cut Diagram|